Makerjuice Easier Pour Top

youmagine

This is a thread-compatible replacement top for Makerjuice resin containers. Makerjuice resin is an absolute standout, but the bottles can be a real challenge to get into your printer. And pouring from them without spilling all over the place? Forget about it! You could try using a funnel, but that's just another item to clean up and keep track of, so I thought there had to be a better way. That's why this top was created. The threads will print without any support needed, and there's a gap between the bottom of the object and the beginning of the threads. Even if you have dimensional accuracy issues with your first layer or two, it won't cause any problems. The top seals perfectly against the bottle, and the top's cap should be snug enough to seal well but not so tight that you can't get it off. If yours comes out too tight, just run a knife over the tip of the bottle topper to shave off a few tenths of a millimeter until it fits better. And don't forget to print it in something that the resin won't dissolve!