Makergear M2 Heated Bed Wire Support Bracket

thingiverse

Important: Be aware that if your machine has a thin glass build surface and a V4 hotend without the heater wire support, using this bracket may lead to clearance issues when setting the zstop properly. A thicker build surface like Mic6 or zebra plate or E3DV6 won't have this problem. This bracket was designed to provide strain relief for Makergear M2 heated bed wires, which on older models flex continuously during printing and cause the wires to break. It attaches to the spider using 20mm M3 screws that fit into the existing tapped holes under the rubber mounts or these alternative mounts: http://www.thingiverse.com/thing:602194 The hole for the wires was designed to hold 1/2" corrugated wire sleeving, but a zip tie on the deans connector works fine too. The strain clamp support attaches to the bracket with M3 screws and nylocks. Enjoy printing! Print Settings: Printer Brand: MakerGear Printer: M2 Resolution: .3 Infill: 95% Notes: ABS