makergear m2 adjustable bed corner clamp

thingiverse

Here are four corner supports that adapt to your glass, eliminating any wobbling and thus rendering binder clips obsolete. You can print a set of these with screws loose enough not to exert pressure on the glass or mic6. Their sole purpose is to remove play from the bed by filling in gaps. A 3mm hole for an M3 screw is located at each corner. I recommend clearing out this hole with a drill bit and tapping it to create the correct thread, allowing the screw to simply create its own threads within the plastic instead. ABS or EPC printing materials are recommended at 100% infill. For newer REV-E printers, you can use the modified design found at www.thingiverse.com/thing:1217210