Maker Select v2 LCD Mount

thingiverse

The Maker Select v2 LCD board allows you to mount it on the bottom right side of the Maker Select frame or have it sit freely on a desktop. **Assembly** Mount the face plate to the LCD board and attach the base to the MS frame using 2 or 4 M3 screws. Three pairs of holes provide multiple height options, but use only the top two screws to avoid compromising the structural integrity of the frame. This will ensure that the bottom two screws remain fully tightened without any interference from PLA. The face plate slides into the base and stays stable on its own, but you can choose to glue it in place for added security. The base features openings that provide access to the LCD board screw heads, even when the bottom screws are slightly obstructed. A small cutout in the back allows the ribbon cable to pass through if you're placing the assembly flat on a desktop. Connect the LCD to the control board using an extended female-to-female 10-pin IDC ribbon cable with a 2.54mm pitch.