Maker Coin Container

thingiverse

I crafted a "Maker Coin" container using OpenSCAD, featuring a threaded lid that screws securely into place. Despite its limited capacity, this coin is an absolute blast to play with and hold in your hand. My design was inspired by these engaging YouTube videos: * Maker's Muse: https://www.youtube.com/watch?v=tGtNLpYSXOU&t=0s * 3D Printing Nerd: https://www.youtube.com/watch?v=Kv1xYpV_yS4 I leveraged the Sine Thread library from mingofmongo to create this part, which significantly outperforms other thread libraries. This results in much faster rendering times - under a minute - compared to the 20 minutes previously required. Check out the Sine Thread library here: http://www.thingiverse.com/thing:261244 If you decide to print it, I'd love to see your finished product! Print Settings: Printer: Monoprice Select Mini Rafts: None Supports: None Resolution: 0.2mm Infill: 20% Notes: Be aware that the tolerance may be a bit too tight. Printing with z alignment set to a specific point yielded better results than using 'shortest' mode in Cura.