Make out with Mistletoe

cults3d

Happy Holidays - hope you get lucky under the mistletoe! There are two versions of leaves as the first one I made used a holly leaf but that is not botanically correct. More information: Kissing under the mistletoe or is it holly? I designed this on Tinkercad and printed in NinjaFlex. The results are uncertain, but the connector may be the issue with other filaments. To keep the leaves and berries properly spaced when hanging, I added a connector that holds everything together. Simply place the leaves in the outside holes and push the three berries through the center hole. If you use a harder filament, consider pushing them into a small piece of Styrofoam for spacers instead. I printed another one in SemiFlex - there's not much difference, except it fits better in the connector.