MagSafe Phone Holder

prusaprinters

<p>This should fit all iPhones compatible with the official MagSafe accessories.</p><p>The only <strong>extra requirements</strong> are <strong>6 cylindrical magnets</strong> (6mm radius, 4mm thickness).</p><p>I recommend printing the threaded bit alone at a 0.1 - 0.15mm layer height, and the other two components at max 0.25mm layer height.</p><p>To add the magnets, figure out the way they attach to the ring of magnets by attaching them on your phone.</p><p><i>*Please note</i> that they attach on both sides to the phone itself, but only on one side to the ring itself.</p><p>The magnets don't need to be glued in, as the fitting is very tight.</p><p>The threaded bit will be a very close fit, use some pliers to thread it into the foot, and then thread the star in.</p><p>I found that positioning the star with one of the magnets on top works better than positioning two magnets at the top. Use the first preview image as an example.</p>