Magsafe Dome Charging Stand

prusaprinters

DescriptionMagsafe charging stand with a unique dome-like design. Works as a desk accessory at the office/home or on a bedside table. Easy to print design.UsagePress fit your magsafe charger (56mm diameter) into the slot at the top.Feed the end of the wire through the entry port at the back of the stand.Roll up any excess wire as needed inside the stand.Press the remaining wire into the hole at the base of the stand.Additionally, you may use some double sided tape on the base for permanent use.Print SettingsMinimum 3 walls for rigidity though you might get away with 2 (2 untested).As there are no flat top layers, realistically you could use 0% infill as the stand should be under no unnecessary stress (though I printed with 10% infill). I have tested with 0% infill and it printed with no issues and still strong enough for normal use.Ensure you have good bridging settings for the cable entry port at the back of the stand.For best visual results, ensure the Z-seam is configured to the rear of the stand.