MagSafe Charging Pad (Dual iPhone or iPhone and Watch)

prusaprinters

<p>Dual charging pad / station for the new MagSafe pucks that the iPhone 12 / 12 Pro uses.</p> <p>The charging pucks just drop in to the cavities, and then are held in place with the screw in backs.</p> <p>The cables are held in a similar way with a similar, smaller screw in retainer.</p> <h3>Print instructions</h3><p>Printed in black PETG. Generic PETG profile used in prusaslicer. 0.2mm layer height, 10% infill.</p> <p>No need for any supports if the top surface of the pad is down on the print surface (so that the cavities face up)</p> <p>Print with top surface down, so that the cavities for the pucks will not require support. The threads on the covers and retainer may need a little finessing as they can be quite tight straight off the printer</p> <p>[EDIT]<br/> Added 4 additional STLs for a single phone &amp; apple watch charging pad. This has not been printed, only modelled after a request in the comments.</p> <p>[EDIT 09/11/20] Additional STL added - charging pad watch small. This should fit on the Prusa Mini.</p> <p>For the dual phone pad:<br/> 1 x charging pad main, 2 x charging pad retainer, 1 x charging cable retainer</p> <p>For the combined phone / watch pad:<br/> 1 each of charging pad watch, watch large retainer, watch small retainer v2, watch cable retainer</p> <p>For the smaller phone / watch pad:<br/> 1 each of charging pad watch small, watch large retainer, watch small retainer v2, watch cable retainer</p>