MagSafe, Apple Watch and Wireless AirPod copper charging station

thingiverse

I wanted a charging station for the desk that can charge iPhone 12 via MagSafe, Apple Watch and the AirPods. Was inspired by https://www.thingiverse.com/thing:3943600 and https://www.thingiverse.com/thing:4634722 so I edited them to add copper pipes. Copper pipe used is standard 1/2” pipe. Will need one tee fitting and 3 pieces of cut 1/2” pipe. The side for the MagSafe is approximately 1.75”. The side for the Apple Watch charger is about 3”. And the pipe from the base to the tee is about 4”. The wire I used for the Qi charger was pjust a spare wire I had laying around. I cut the plastic around the plug that goes in to the board so that it fits in the base. Fish all of the wires through the pipe and out the back. Of the base. If the pipe is loose once you put it together you can put a small piece masking tape on the pieces that fit in to the printed fittings to make it snug. You could also add a drop of glue but I wanted to keep it unglued in case I want to take out the chargers at a later time. Parts used: Qi Coil https://www.amazon.com/dp/B08DFF1W2W/ref=cm_sw_r_cp_api_fabt1_eDiUFbJ57B1BW 1/2” copper pipe 4 m3 screws by 5mm (don’t over tighten) Spare micro usb cable Masking tape Optional multi port charger so that only one wire goes in to the outlet. This is the one I used, but any should work. As long as the one for the MagSafe is supplying at least 20w https://www.amazon.com/dp/B088TFZ942/ref=cm_sw_r_cp_api_fabt1_yKiUFb99A8GQR