Magsafe 2 cable protector

thingiverse

Magsafe 2 connector cable support is designed to keep the power connector cable at right angles. The power cable eventually goes out of alignment and stops working, so I bought another power brick but it also started to fail in the same place. Since there was nothing else suitable, I created this item. A cable/zip tie is required for installation. I redesigned the cable grip again, extending it to enclose the charging tip completely, narrowing the central opening to hold the cable in place without a zip tie. Top and bottom recesses were also added for the zip tie, allowing it to be used without one if the charging tip fits snugly. After cleaning out the supports, I inserted my charging tip, which has a very tight fit due to an improper overhang print.