Magpul-style picatinny angled foregrip

cults3d

I designed this afg in style of Magpul's M-Lok AFG, but for picatinny rail. You will need two M3 hexnuts and M3 screws. The length of the screws depends on how strong you tighten them (i recommend 2 Nm). They need to be flush with hexnuts or the grip will be uncomfortable to hold, so sand them down a bit if necessary. For me a M3x25 is good. Goes without saying, but don't install it near heat sources (gas block, chamber), unless you print it from some highly temperature resistant material.