Magpul PRS bag rider agressive angle

thingiverse

I wasn't happy with the angle of the stock Magpul PRS v2 and decided to create my own. This replaces the bottom plastic piece on the Magpul PRS v2, not sure about other versions. Simply remove a single screw on the bottom front of your PRS stock, then the lower plastic piece will slide forward & off, then just slide this on to replace it. I did have to tap my model on towards the last inch or so but that's ok as I want it to fit really tight for accuracy. I included both the STL file and a 3mf file for Prusa Slicer which has the Fuzzy Skin settings ready to go with a sandpaper like skin. This allows it to grip your hand or bag better and not move, again improving accuracy. Printed on a Prusa mk3s in 0.2 layer height using eSun ASA but PLA+ or PETG should work as well. Keep in mind that PLA parts might not last as long as PETG/ASA in the sunlight since UV breaks it down over time. Support is only needed for the screw hole area, the 3mf file already includes pre made supports as seen in the pictures.