Magnificent Fluffy ~ Cat with Top hat

thingiverse

This remix brings together two designs from Thingiverse to create a new cat model. You can print this design with the top hat attached or separately. Separating the top hat is recommended as it simplifies support removal. Don't worry about support within the hat, as it will detach easily. This 3D printed design measures roughly three inches tall, and two inches without the top hat. There's potential to expand this into a series called 'Fancy Cats'. Always provide credit to both original designers when remixing, and don't forget me in the process. Print Settings Rafts: No raft was used. Supports: Supports were necessary for printing, as shown on the cat model. Resolution: Unfortunately, my print settings tool did not display the resolution properly. Infill: I filled in the model with a level of infill corresponding to the still-unavailable resolution information. Notes: I did not use a raft but left an imprint of a net/graph design on the underside of the cat. It might be worth smoothing it out, though this is not crucial as it won't be visible unless viewed from below. Post-Printing Currently, I don't have images of the printed model; however, additional pictures will soon be available! Front Right This section needs images to properly display the 3D print result. Front Left Front view Back Left Cat's side Side [Right] Feline rear profile Front View from directly in front Bow tie and tail are printed together in one single print piece as a cat. Close-up Diagonal Front Right Diagonal frontal print showing feline texture and detail Close-up Face/Front Up close view of the feline's face. Bow Tie [on Neck] Print displays small bow on top part.