Magnets for 2020 extrusion

thingiverse

I secure my PC-covers on the printer using standard magnets purchased at a hardware store for use on doors. Please see the accompanying image. After a period of time, the plastic began to crack, prompting me to design this replacement solution. The magnets are 25x15x7mm in size: they consist of two iron parts on either side and feature a hole running through their center. Please refer to the provided image for further clarification. This part was specifically designed to accommodate 5mm bolts. To assemble the component, simply place the magnet within the main section and then push the pin from the upper part through the magnet and into the base. Applying some heat will cause them to melt together seamlessly. I am once again satisfied with this setup.