Magnetic support for Logitech C270 on Wanhao Duplicator I3 Plus

thingiverse

I spent a considerable amount of time searching for a way to mount a camera on my Wanhao Duplicator I3 Plus, and after much trial and error, I finally found the ideal location - directly behind the right X-Y carrier. It's perfectly discreet and follows the nozzle with precision, allowing me to check the current printing status at all times. The holes for the magnets are quite tight, so it's essential to use a 6mm drill to ream them out before inserting the magnets using a pair of pliers. To complete this project, you'll need the following parts: * Four neodymium magnets (each measuring 6x10mm) * Screws (M3x12 and M3x20) along with one small washer and two nuts - a 1/8" nut should fit perfectly One thing to note is that my C270 camera has its focus set at 40cm to infinity. To modify it for manual focus, I recommend checking out the following part: https://www.thingiverse.com/thing:2366968