Magnetic screwdriver bit holder for drill driver

thingiverse

Most cordless drill have a magnetic holder on the side to hold frequently used screwdriver bits. My Aldi Workzone didn't.. see photos. I looked for a place to fit my own and found the nameplate area would be a good place. In Tinkercad I started to design a thin holder with a near half hex cut out along the length. I found some strong but small magnets on the magnetic lid boxes that are commonly used. I cut out another hold in the base of the design to accommodate these magnets. I didn't want to glue these holders on. I already had some nano tape.. see photo .. like a double sided tape but reusable. These two hold most of what I want to use now.. you might need to modify the design for your own use but the ides is there.