Magnetic mount for round LCD thermometer/hygrometer

prusaprinters

<p>Holder for the cheap little thermometer/hygrometer available on Amazon (part number B07BLY177S). Along the same lines as my <a href="https://www.thingiverse.com/thing:3060923">ugly little holder</a> but now with magnets for mounting to steel surfaces.</p> <p>Uses 8x3mm magnets which are also available from Amazon (part number B07B3SDRCP). I have many of those on hand since I bought them for some other project and it comes in a pack of 100.</p> <p>Print out the thing, and then press a magnet into each of the holes. For mine, I found sticking the magnet on the end of a <a href="http://bondhus.com/pages/hex-end">6mm hex T-wrench</a> helped me push it in, as it was a nice tight fit. Press the magnet so it's flush with the back edge for the best holding power.</p> <h3>Print instructions</h3><h3>Category: 3D Printer Accessories Summary</h3> <p>Holder for the cheap little thermometer/hygrometer available on Amazon (part number B07BLY177S). Along the same lines as my <a href="https://www.thingiverse.com/thing:3060923">ugly little holder</a> but now with magnets for mounting to steel surfaces.</p> <p>Uses 8x3mm magnets which are also available from Amazon (part number B07B3SDRCP). I have many of those on hand since I bought them for some other project and it comes in a pack of 100.</p> <p>Print out the thing, and then press a magnet into each of the holes. For mine, I found sticking the magnet on the end of a <a href="http://bondhus.com/pages/hex-end">6mm hex T-wrench</a> helped me push it in, as it was a nice tight fit. Press the magnet so it's flush with the back edge for the best holding power.</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> i3 MK3</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.2mm</p> <p><strong>Infill:</strong> 25%</p> <p><strong>Filament:</strong> Prusament PETG orange</p>