Magnetic Light-Ring for Dremel 220 Workstation

thingiverse

Just a few days ago, I published another version of the Light-Ring for Dremel 220. In that occasion, I suggested upgrading by using magnets. When I came up with the idea, I couldn't resist doing it myself. With respect to the older version, you'll find several changes: - Magnets are placed on the back side of the holder outer.stl. - An additional STL is included for printing (magnet holder.stl). It's necessary to properly fix opposite magnets on Dremel Workstation around the locknut. - In this case, LEDs are flush with the holder outer.stl component. This change was necessary since LEDs can obstruct tool tightening into Dremel. - This version is absolutely cooler than previous one. I used six neodymium magnets with sizes 5x10x1mm for this upgrade. Note: pay attention to magnetic polarity before fixing everything! Enjoy!