Magnetic Lid Companion Cube Coin Bank

thingiverse

This is a remix of the Companion Cube Coin Bank by Cool_Stuff, remixed from Landru which makes the lid magnetic. It uses the below 6mm x 3mm cylinder magnets: https://www.amazon.com/gp/product/B07MX57ZGK/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1 Make sure to orient the magnets correctly before gluing so they pull towards each-other. If the fit is too tight, you can try a couple things: 1. Try printing at a slightly larger scale like 100.01% 2. Drill or sand the holes open wider 3. Try gently hammering them in against a block of wood (don't hammer the box directly) I recommend using 2-part epoxy to glue the magnets. The 5-minute cure kind that comes in the tubes should work great. Don't use CA (super) glue. Enjoy the magnetic action!