Magnetic KitchenAid Accessory Mount - Parametric

prusaprinters

<p>This model is a remix of <a href="https://www.thingiverse.com/thing:4340836">https://www.thingiverse.com/thing:4340836</a> which itself is a remix of <a href="https://www.thingiverse.com/thing:3252061">https://www.thingiverse.com/thing:3252061</a>.</p> <p>This is a mount for KitchenAid stand mixer accessories which is intended to have an embedded magnet, in order to allow you to attach it to the underside of a magnetic surface--in my case, my microwave.</p> <p>This model has some parametric variables in case you have a different size or strength magnet and want to adjust. The model as designed fits these magnets from McMaster Carr: <a href="https://www.mcmaster.com/5862K111/">https://www.mcmaster.com/5862K111/</a></p> <p>My model has been measured and created from scratch and does not actually use any measurements from the originals from which it draws inspiration.</p> <h3>Print instructions</h3><p>My Slicer project configuration is included as a download for reference, but I printed as follows:<br/> Supports:<br/> Yes - Strongly recommended on obvious overhang</p> <p>Resolution:<br/> 0.2mm</p> <p>Infill:<br/> 5-10%</p> <p>Filament_material:<br/> Doesn't matter too much. PETG might be better but I used PLA as these don't hold a lot of weight</p> <p>Notes:<br/> My print project is included to illustrate where I added supports, and it also includes a pause at 6mm in order to allow for embedding of the magnet.</p>