Magnetic Fishing Game for Kids

prusaprinters

Instructions:Print without supportSome thin rope to attach the hook to the fishing rodMagnets 10MM X5MM round for the hooks and the box (4pcs total)but smaller magnets will also work! Just put some tape on them.M6 nuts for the lid (2Xpcs) but any metal is good if it fits! Dimensions: 5 mm height, diameter 10 mmIf desired: Small piece of metal wire for reinforcing the joints on the boxFor the fish, use a washer M10 (10pcs)  Tip: use some glue on the magnets when inserting them, and wait a minute. Otherwise, the magnets could pop up on the heat block screw!In the new version all the washers, bolts and magnets are inside the print!Tank you @BikeCyclist  for this idea.when slicing the case, hook and fish; place a pauze mid print:For attaching the rope to the hook, a pushpin could help.  Make a small knot and pull the rope back into the hole.