Magnetic Charging Dock for Miyoo Mini (Remix of FrancosCustoms) and USB C Washer

thingiverse

This is a remix of "Miyoo Mini Charge Stand / Dock" by FrancosCustoms (https://www.printables.com/model/202564-miyoo-mini-charge-stand-dock) to use with a magnetic usb c charging cable. Also created a usb c washer to slide down over the usb c post to add support and take up the gap between dongle and device. Some of you may look at this and see alot of jank (especially around the connector). I am not well versed nor practiced in 3d design, but I wanted to give it a shot. Utilizes charging cable (or similarly designed):https://www.amazon.com/dp/B09DKRQXPC?psc=1&ref=ppx_yo2ov_dt_b_product_details I also added some “jeweller's velvet” to give it some cushion as well as 2 layers to the left of the charging port so the miyoo sits squarely: https://www.amazon.com/dp/B08PVKV1BQ?psc=1&ref=ppx_yo2ov_dt_b_product_details Charging stand I printed at 101% in cura 5.0. Washer at 100%. 30% infill to give it a little weight. No supports. Printed both the washer and charging stand on the same build plate with a brim. The washer is very small and tends to fail printing without a brim on PEI. Printed on an Ender 3 Pro with 0.4mm nozzle. Included a test block section of the dock you can print to see if your magnetic charging cable will fit without needing to print the entire dock. I AM IN NO WAY RESPONSIBLE FOR ANY DAMAGES INCURRED OR OTHERWISE BY YOU PRINTING AND USING THESE MODELS