Magnetic Bracket for Enclosure - 1" Remix

thingiverse

I saw this design and wanted to use it immediately, but unfortunately, I didn't have all the necessary magnets on hand. Luckily, I had some 1" x 1/32" N52 neodymium rare earth magnets leftover from a previous project that I could utilize. If you're interested in getting your hands on them, here's a link to purchase: https://www.kjmagnetics.com/proddetail.asp?prod=DX001-N52 I also added a cross-sectional view of how I adjusted the screw cap to fit perfectly with the bracket. To ensure a snug yet comfortable fit, I left about 0.5mm gap between the two parts. This way, I wouldn't have to resort to sanding down the sides if it was too tight a fit. Additionally, I left 0.9mm gap for the 1/32" thick magnet, which should provide just enough clearance. If this proves to be either too little or too much space, I can always adjust accordingly and re-upload the design. To make the design look even more polished, I also added some fillets throughout. I'm a big fan of rounded edges, as they give the design a sleeker appearance. While it's possible that these curves might not be necessary without them, I'll be happy to re-upload the design if needed.