Magnetic bit holder

prusaprinters

Magnetic bit holder, models from 4 to 15 bits (2x2 to 3x5).Uses 6x2mm magnets on both sides, back sides have enough holes, install as many magnets as you need. Holes have taper, so there should not be need for glue. 6mm hex is pretty handy when installing magnets to the bit holes. Polarity is important on the back side, so don't flip the magnets after taking from the stack..3mf is painted. Print with seams at the back so the seam orients to the corner of the hex, 3mf has this covered. 0.20mm and 2 walls works well, bottom down, no supports.