MAGNETIC BABY LATCH MOUNTING HARDWARE

thingiverse

YOU NEED M3 SCREWS AND M3 SQUARE NUTS, DRILL FOR M3 SCREWS AND 5/16 DRILL FOR M3 SQUARE NUT CARTRIDGE. FIGURE OUT PLACEMENT OF LATCHS MARK WITH PEN THEN CLAMP DRILLING BRACKET TO THE DOOR. TAP 5/16 DRILL WITH DRILL DEPTH THROUGH THE BRACKET DONT DRILL MORE THEN NEEDED. EVEN WITH BRACKET HOLD DRILL STRAIT AND DONT DRILL TOO FAST. CLEAR CHIPS AS NEED. DRILL SIDE HOLE AND 2 BACK HOLES FOR M3 SCREWS. ONCE ALL HOLES ARE DRILLED PUT M3 SQUARE NUTS IN TO THE CARTRIDGE. INSERT WITH GROOVE FACING OUTWARD. CARTRIGDE SHOULD BE MIRRORED FOR EACH DOOR. M3 NUTS SHOULD BE LOADED UPWARD AND GOOVE SHOULD BE FACING OUTWARD. ONCE CATRIDGE IS INSERTED MAKE SURE GROOVE IS PARALLEL TO THE DOOR. THEN SCREW IN M3 SCREWS BE SURE TO NOT CROSS THREAD THEM. WHEN DRILLING HOLES DO NOT DRILL PAST 5/16 HOLE AND DO NOT DRILL THROUGH THE DOOR!!!