Magnet Holder

thingiverse

A Simple Magnet Holder Design. This project requires a few basic components to pull it off: * 10pcs 10mmx20mm Magnets with 4mm Hole * 10pcs M4 12mm Countersunk Screws (Bauhaus Bulk) * 10pcs M4 Standard Nuts, 3mm Height (Bauhaus Bulk) Note that the nut is not strictly necessary, as you can screw the M4 directly into place. However, if you want to add an extra layer of security, there's a socket inside both the top and bottom models where you can apply some Loctite for added grip. The total cost of this project comes out to approximately $6: * 4 Magnets: $3 * Screws and nuts: $1 * Plastic (approx. 28g): $2 Print Settings: ----------------- Printer Brand: Wanhao Printer Model: Wanhao Duplicator i3 V2 Rafts: No Supports: No Resolution: 0.2000 mm Infill: 100% Notes: * Extrusion width: 0.25mm * Extrusion multiplier: 0.97 * Top/Bottom solid layers: 1 * Outer/perimeter shell: 2 * Heatbed temperature: 65°C with glass bed * Nozzle temperature: 230°C * Filament used: Prima Value PLA