Magnet Holder 20x10x3 (Lack Enclosure)

thingiverse

#Magnet Holder# ####For IKEA Lack Enclosure#### I needed magnet to hold the doors closed on my IKEA Lack Enclosure https://www.thingiverse.com/thing:4705780 I've decided to create minimalist design, where one magnet in the middle holds both doors by screws holding small handles (together 4 magnets for the whole enclosure). Size of the used magnet: **20**x**10**x**3** mm Mount with **wood screws 3x16** mm **_Optimized for 0.4 mm nozzle and 0.2 mm layer height._** *I've covered magnets with a transparent tape, so screws/nuts are not hitting magnets directly.* #### Update 29 April 2021 #### After few months of usage I've created **Magnet Holder v2** - Added one layer to cover magnets - Protects the magnet - Reduces noise when closing doors - **Requires setting up "Detect thin walls" in PrusaSlicer** - Rounded edges - Protects your hands :) - Changed orientation - no need for support - Thanks to the layer for covering magnet it can easily print good looking bridge - *Depending on your bridging quality, you may found some magnet not fitting fully - in that case you can smoothen the inner area (bottom of the bridge) using some tool, e.g. small flat screwdriver*