Magnet Clip for Stereo Remote

prusaprinters

<p>I designed this to keep my stereo remote within arms reach in the garage as well as keeping it off my work surfaces in a dedicated location (small countersunk magnet screwed into stereo shelf). This prevents losing the remote and I'm rarely caught unprepared when I want to crank the volume up (or down).</p><p>It was designed to fit an Aiwa RC-L70 and has an opening of approximately 2.5x0.65" with a draft so it fits snug and will flex when installed, keeping it in place on the remote. It's possible it might fit other remotes as-is or with some scaling in the slicer. YMMV</p><p>There's a 12x3mm neodymium magnet glued into the hex pocket.</p><h3>Print Instructions</h3><p>Printed in Overture PETG at 0.3mm layer, 3 perimeters, 10% infill, and no supports.</p>