Magic Tripod Levitation Stand

thingiverse

Three-Legged Levitation Stand: A Simplified Version Derived from the four-legged levitation stand found on thingiverse.com/thing:4070060, this design eliminates the wobble issue present in its predecessor. By rearranging the holes for the lines, a single continuous line can be used to secure all outer lines. Setup Instructions: Print both parts and then follow the diagram to thread through the lines. Begin by adding the inner short line (green), followed by attaching the outer line (red) at one end. Carefully thread it through to the other end, pull taut, and tie off securely. A needle proves to be a useful tool for threading through the line. If the top becomes unstable due to sliding lines, apply some tape, superglue, or wedge it firmly into two of the through-holes to stabilize the structure.