Magic Bullet Hanging Mount

thingiverse

This is a straightforward under-cabinet mount to hang a Magic Bullet blender. The mount screws into two simple holes, then the Magic Bullet connects through the same ports you would normally use for the blending cup. I highly recommend printing this with supports in place. Most printers can produce decent clips on the edges, but without them, the adhesion between the body of the mount and those clips can be a bit tricky. The clips bear all the force when hanging the blender, so if they're not stuck well, they'll snap off easily. As an added note, unplug the blender before you start. It might turn on automatically, but it won't cause any harm, although it could still be startling and that might hurt something.