Mage Knight Token Holder (with LL)

prusaprinters

I really liked the token holder made by Sislar, but ahd a few changed I wanted to make. I deepened the crystal holding part to give extra room and I changed the stack heights so that each column would be exactly the height of the enemy tokens. I didn't change the lid, but highly recommend using an exacto knife to cut out little squares in the corners so that the lid slides in and snaps in place. I didn't change the model since results will vary with printer tolerances, but if you are really careful and cut off a sliver at a time, you can get it so it just barely snaps in and stays in place. Has room for base plus lost legion tokens. need a separate one for tezla enemies that I'll upload soon. Category: Toys & Games