Made in USA stamp

thingiverse

Use this stamp to show your pride in your products and where they're made! The curved version can be used like a regular stamp, with either an inking pad or block printing ink rolled onto a glass palette. Heavily ink the printing surface of the stamp and roll onto your paper in a single side-to-side motion. If you need to rock the stamp side to side, you didn't use enough ink. The flat version won't make a great stamp (since it isn't flexible) but is instead meant to be used like a block print. Ink the printing surface with an inking pad or apply block printing ink with a roller and place the stamp on a sturdy flat surface with the inked side facing up. Then, place your paper over the top and rub the back surface of the paper with a block printing baren or something similar (like a spoon), being careful not to shift the position of the paper on the stamp. I printed this on an Anycubic Photon UVLED printer at a 0.05mm layer height without supports, and then sanded the ridges from the printing surface with #2000 sandpaper. If you use this design on your products, please consider posting a picture in the makes section. I'd sure love to see it!