Madame Jeanette, rc airplane, speed 400 size pylon racer

thingiverse

Madame Jeanette. This is a very fast pylon racer, use a 3 cell battery for fast flying, use 4 cell battery for extreme flying. Designed for Lightweight PLA, strong construction, and still about the same weight as a traditional wooden airplane. Use thick ca glue, with activator spray. Needed equipment: See PDF Wingspan: 720mm Weight: 420 to 500 gram Control throws: elevator:3mm up and down Ailerons: 6mm up and 3mm down. Minimum print area 220x220x250mm Cura printer settings: LWPLA To prevent stringing, print only one part at a time. Use Cura std quality 0,2 as a start setting, modify with: Layer height: 0,2mm Line width: 0,4mm Wall line count: 1 Z seam alignment: User specified, back Top/bottom layers: 3 Infill: Gyroid, 4mm line distance Printing temperature: 235, build plate temperature: 60, Flow 55% Speed: 40mm/s No support Build plate adhesion: Brim 3mm PLA (P1) Use Cura std quality 0,2 as a start setting, modify with: Layer height: 0,2mm Line width: 0,4mm Wall line count: 1 Z seam alignment: User specified, back Top/bottom layers: 4 Infill: Gyroid, 3mm line distance Printing temperature: 215, build plate temperature: 50 Speed: 40mm/s No support Build plate adhesion: Brim 3mm PLA (P2) Use Cura std quality 0,2 as a start setting, modify with: Layer height: 0,2mm Line width: 0,4mm Wall line count: 4 Top/bottom layers: 4 Infill: Grid, 100% Printing temperature: 215, build plate temperature: 50 Speed: 40mm/s No support Build plate adhesion: skirt 3mm