Mack Rides Xtreme Spinning train body for LEGO/Micro K'nex

thingiverse

This is a model of a Mack Rides Xtreme Spinning train designed to attach to K’nex roller coaster cars for LEGO riders. Parts: For every K’nex roller coaster car you will need 2 car bodies, 4 restraints and 4 axles. Application: To use this, remove the coloured top parts of a K’nex coaster car using a screwdriver and attach the new train body onto the black chassis using adhesive, unfortunately this model does not have holes to attach using screws. Attach the front model onto the front and back onto back with the bar from the front base overlapping the back. Then slide the top onto the bolt and screw on the nut to secure it. A demo image has been included to show where the 2 base pieces should be attached, note this image does not feature an actual image of this model. Restraints: To attach the restraints, place over the seat and slide an axle into the gap. I haven’t printed this myself so have listed this model as work in progress as I cannot be certain it will work but I strongly believe it will. The model should be to scale and the restraint has been designed to fit around a LEGO figure securely whilst leaving enough space for most LEGO hairstyles but not all will fit. There should be enough friction in the restraint axle to hold it securely however if it is too loose then you will need to increase the diameter or the axle slightly. As this design originally belongs to Mack Rides, I can only give permission for non commercial personal use. All measurements in centimetres (cm)