Macintosh SCSI2SD Bracket

prusaprinters

<p>This 3D printed bracket is designed to mount a SCSI2SD to the 3.5" hard drive bay on vintage Macintosh computers. It works with both SCSI2SD v5.1 and v6 models, and has been tested with the Macintosh SE, SE/30, Classic II, LCII, and Performa 476.</p> <p>I would also expect it to fit in a Classic, LC, LCIII, or other Macs from the same vintage. The mounting holes are based on the early MiniScribe stepper motor drives, and the later SCSI drives.</p> <p>Features:</p> <ul> <li>Gigantic SCSI logo!</li> <li>Sides are the exact same height as the SCSI connector</li> <li>There's space underneath the LED header holes, so you can solder a pin header in</li> <li>Positive pin marking next to the LED pin header</li> <li>SD card indentation shows card orientation, and helps line up the card</li> <li>The potato is completely hidden when the SCSI2SD is installed</li> </ul> <p>Installation:</p> <ul> <li>On the SE, SE/30, Classic, and Classic II, the SCSI logo will face up</li> <li>On LC-series machines, the board will face up</li> <li>Uses four M3x8 or M3x10 screws to attach the board to the bracket</li> <li>Reuses the original hard drive screws to attach the bracket to the Mac</li> </ul> <p>If you don't have a printer and would like to buy one, you can find it on my Etsy shop: <a href="https://www.etsy.com/listing/828766404/macintosh-scsi2sd-bracket">https://www.etsy.com/listing/828766404/macintosh-scsi2sd-bracket</a></p>