M6 Nut Funnel Cover - Exruder Filament Guide

thingiverse

Funnel-shaped guide makes threading filament into the Monoprice Select Mini 3D Printer's or Malyan M200 bowden tube easier. It works like my M6 Funnel Bolt - MK8 Extruder Filament Guide, but for standard setup. This was designed specifically for use with 1.75mm filaments; it will not work with 2.5 or 3 mm filaments (the hole diameter is close to 2.55mm). Should be printable without supports. I have only done test prints using a 0.4mm nozzle and a 0.8mm wall/shell thickness, other options were not tested. Fastest way to install is by pushing in on the blue release ring on the nozzle and pulling the bowden tube out of the nozzle. Then unscrew the nozzle from the M6 nut and install this adapter (the uncovered edge of the nut should be at the bottom). Reassemble in the opposite order. Update: Added a "wide" version (M6_W_Nut_FC_v004.stl) for the newer Select Mini / M200 models that use a thinner M6 nut to hold the bowden tube in place. The wide version has a width 50% greater than the original.