M3 T-slot nut holder

thingiverse

Instructions for Customizing a Modular Nut System Using the following options to tailor your modular nut system: * Increase nut number in y-axis direction: Set nut_num_y to 7 * Adjust nut placement on x-axis: Set nut_num_x to 3 * Specify screw diameter: Set screw_rad to 2.0 * Rotate nuts: Set nut_rotation to 45 degrees * Extend total length of nuts: Set total_nut_length to 20 * Thicken washers: Set washer_thick to 1.5 * Change nut width: Set nut_width to 6.23 * Narrow slot width: Set slot_width to 9.0 * Increase nut depth: Set nut_depth to 3.2 * Shift middle slot position: Set slot_middle_offset to 4.5 * Raise total slot height: Set slot_total_height to 4.8 * Adjust edge slot height: Set slot_edge_height to 1.2 * Enlarge washer diameter: Set washer_rad to 6.3