M3

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: Pulley diameter set to 20 millimeters. Number of nuts specified is one. Motor shaft selected is three millimeters in diameter. Idler setting is off by default. M3 nut hex value is set to one. Additional tooth width adjusted to 0.2 millimeters. Retainer height set to 1.5 millimeters. Pulley block height specified is eight millimeters. Idler height adjusted to 1.5 millimeters. Additional tooth depth set to zero by default. Teeth count selected is ten. Retainer toggle off by default. Profile chosen is six millimeters in diameter. Nut shaft distance set to 1.2 millimeters. M3 nut depth specified is two point seven millimeters. Nut angle locked at ninety degrees. M3 nut flats adjusted to five point seven millimeters. M3 diameter set to three point two millimeters. Pulley throat height selected is twelve millimeters.