M2x6 22nd march

thingiverse

Using the Customizer tool at Thingiverse.com, a custom version of the bolt design can be created. This involves specifying various parameters to alter the design. To do so: Options used: Bolt type selected as: Phillips head No non-thread diameter set. Six facets are included in the design. Thread step is set to 2. Socket type selected for the head. Outer diameter of the bolt is 14 units. Height of the head is set to 1 unit. Shape angle of steps on the bolt is set at 45 degrees. Texture is excluded from the bolt. Inner diameter is specified as 8 units. Nut size chosen: 12 units in diameter. Thread step distance is set to 0.4 units. Head width measured as 3.2 units in diameter. Outer thread diameter for the nut is set to 9 units. Resolution is set at 0.5. Height of the nut measured at 6 units. Nut angle shape adjusted at 45 degrees. Drive pin size set at 3 units. Distance from end of bolt to outer edge of threads is 2.3 units in diameter. Length of thread specified as 6 units. Ridge separation distance for slot and wings set at 1 unit for a single ratio setting. Bolt width selected at 2 units, which matches thickness measurement. Step resolution set the same for nut as rest of bolt, which remains 0.5. Additional parameter included to indicate no non-thread part or section exists on this design. Depth measure set at 1, signifying that countervented holes may occur. Standard selection applied by setting countersink size to 2 units and width chosen for a 0.5 slot size. Last selection confirms regular nut as preferred component type