M200 Z-Axis Bracket

thingiverse

This is technically a remix of this design MP Select Z-Axis Bracket by kingofl337, I redesigned it to accommodate shorter 12 mm socket head M3 screws for easier install, also added a bit more tolerance to the fit of the back hex nuts. You'll need to print two sets of these for top and bottom of the rails. Print Settings: Printer: MP Select Mini Rafts: Doesn't Matter Supports: No Resolution: 100 microns Infill: 40% Notes: I used a higher amount of infill so the part would cut down on vibration. Post-Printing: Installation: These are pretty easy to install, once you have the two z-axis panels off. If you need help with that, Life and Times of Tyler makes some really great videos. I used some screws and nuts I got from Inventables. M3 12mm length 0.5mm pitch Socket-head screws M3 0.5mm pitch nuts No washers needed To make installing these easy, I dropped the hex nuts in the back bracket part and put a piece of masking tape over them to temporarily hold them in place. I installed the top bracket in place but loosely installed the bottom bracket in the middle then slid it down into place before tightening it. Tighten each screw a bit, then go back and tighten again until they are a bit hard to turn.