M200 fan bracket with standoffs included (10mm or 15mm)

thingiverse

Added standoffs to the Thing via TinkerCAD. TinkerCad URLs: https://www.tinkercad.com/things/euq0vNNKPMM-mpsm-fan-bed-with-15mm-legs https://www.tinkercad.com/things/fuXjM8w5bWa-mpsm-fan-bed-with-10mm-legs Still using the original component, haven't installed it yet - standoffs should fit between components nicely. First draft was a mirror image of what I needed. Update: Installed and working perfectly now - plenty of space for posts. If you're using the fan header on your motherboard, you'll need motion firmware v26 or above, as I understand it's not enabled on earlier versions. Also, you may need to swap the wires over on the fan for it to work since they made a mistake when wiring the header. Before swapping any wires, test your fan on the header that powers the head cooling fan. If your fan works there, it will work on the motherboard fan header too. If not, swap the cables on your new fan in its connector and retry it. Wires can be easily pulled out of the connector by pushing a small lip at the end nearest to the cable - gently push that in away from the edge that connects to the motherboard. 40mm fan