M1841 Napoleon 6-pounder field gun (1:5 Scale)

cults3d

This is not intended to be useable as a 3D printed item or casted item, and I make no promises or guarantees, nor hold any responsibility for any injury or damages caused by misuse of this model. This is in progress, I'll update as the project continues. The project is a pattern for sand casting a 1:5 scale M1841 Napoleon 6-pounder field gun. Design is based off of several sources of measurements and the general appearance in historical photos. The approximate bore size should be 0.75 inch at this scale, the hole in the complete STL is accounting for the outer diameter of a pipe with a 0.75 in ID (0.875 in OD). Parts required to print the pattern: 2x Muzzle half 2x Reinforcement half 13x 1.000 inch pins 2x 0.375 inch pins 1x 0.500 inch pin The pins will fit very tightly, and may be too long, some sanding and trimming may be necessary.