M14 Selector Plate - Classic Army | Tokyo Marui | G&G etc Airsoft

thingiverse

This is a replacement selector plate/arm for a Classic Army Airsoft M14 I have been repairing. The original had snapped off and the gun was stuck in full automatic only. The part was made for this classic army but the G&G is the same design and I'm almost certain the Tokyo Marui, Cyma and others are the same on this part too, even though they differ elsewhere. I printed at 0.2mm layer height with 100% infill and it printed in 20mins with no filing/adjusting needed. The fit is quite snug and it has a nice detent at each end of the rotation on the fire selector. I used supports but it's only a tiny section underneath the screw hole where there's a recess for the other half of the selector plate to screw on. This might not be necessary.