M12 Vacuum Packout Legs WIP

thingiverse

These are legs for the M12 vacuum that I created to make it packout compatible. They are modified from the packout legs from Electronsmith's website. The legs are all different and location specific. The name of the legs is relative to looking at the vacuum from the front of the packout system. You'll need bolts sized #8-32 that are 1&1/4 inch long 1/2 OD rubber washes as well as regular washers. I used the regular washers on the outside of the vacuum to help balance out the legs to make it easily slide in and out. The rubber washers go on the inside to help seal it. You'll need: 10 - size 8-32 bolts/nuts, 1&1/4 inch long, cut these down once you get a good fit, specifically on the front legs since the filter will not seat if they are kept at full length. 10 - 1/2 OD washers A few regular No 8 flat washers. I placed the legs in the packout system, put some double sided tape on top of the legs and then put the vacuum on top to place the legs correctly. It may require a bit of trial and error to get the perfect fit. I recommend printing in PETG or ABS