M1060 magnetic earcup adaptor 110mm

thingiverse

I am new to 3d modeling. This design is for monolith m1060 earcups. I purchased some dekoni 110mm and they came with glue. However they didn't stick very well. Made these rings to attach them magnetically. Should work with any 110mm earcup. Print settings shouldn't really matter as this isn't close tolerance. Be sure the magnets are facing the correct way. used tiny 3x1mm magnets. the holes are a little larger than 3mm to accommodate for printer inaccuracy. glued the rings and the magnets using cyanoacrylate NOTE *There are 2 magnets in each hole in the "inner ring" and 1 on the part that is glued to the earcup * the smaller ring is attached to the driver - larger goes inside the earcup Magnets used: https://www.amazon.com/dp/B09MQ3JXLV?psc=1&ref=ppx_yo2ov_dt_b_product_details