M1 satellite receiver mount bracket

prusaprinters

After damaging a Satellite Receiver which was stuck to the frame on a sticky pad, decided to make a mount so that the Receiver could be mounted under the canopy and easily removed.  The bracket fits a 15mm x 22mm Receiver and holds it at a angle to clear the servo plugs and allows the flight controller LEDs to be seen. Being easily removeable, makes it practical to share one receiver with two helicopters.  I also used  two small pieces of sticky pad under the aerials and a tiny piece of Sellotape / Scotch tape to hold them in place.I recommend printing it in PET_G.