M&P 15 AR style front shield and pistol grip

thingiverse

A remix of some other front grips and shields for an M&P15 style AR 15, I split the shields so they would print better on my machine. If you print the combination pistol grip and front shield, you will only need one of the front grips. These were about 1mm too long and needed to be trimmed on the forward end to fit my rifle - you may or may not find this to be the case for your use. Also, the pistol grip is a remix of another great job I found here on Thingiverse. I removed the side rails and sunk it into the front shield because the rails were too loose. The original was very well done and I basically just chopped the rails off - so some sanding and filing may be needed to clean things up, which should not be more than most prints need. However, I am not yet finished printing it - I will update if it turns out poorly. Thanks. 12/31/2017... I have now completed my print and it fits well. Not much file work was required. I did, however, have to shorten the muzzle end by a mm or so - just as I did for the other half.