M-LOK Rail Covers and Handbrakes

grabcad

I downloaded every m-lok rail cover I could find and just did not find one that I liked. So I created ones that fit my particular need. Then I decided to make all the variants so there are multiple options for anyone else's needs.Sizes 1, 2, 3, 4 relate to number of m-lok slots that the rail or handbrake occupy.Short versions can be stacked one next to another.Long versions are slightly extended ends, primarily to be used as a single cover. If used with another rail, hole spacing may not align with slots on multiple rail coversOh, and if you need the M-LOK hardware, don't over-pay $20+ for 8 screws and nuts on some gun site, just run over to Amazon and stock up.  M4x10mm work great for these rails and other slim M-LOK accessories.  M4x12mm work for thicker M-LOK accessories.  Standard M4 T-Nuts are not quite as wide as the slot in M-LOK rails, but they are wide enough to not spin and they tighten down just fine.  Youay need to adjust side-to-side a tad to make sure they are straight, but they work, nonetheless.  Most of the T-Nuts I found are shiny nickel plated.  A $2 can of flat black spray paint from Walmart fixed that.  Sprayed 100 nuts, both sides, in less than 15 minutes.  (thanks to the hot Texas sun in August for fast-curing the paint - YMMV) M4 10mm Screwshttps://smile.amazon.com/dp/B08HLRMGRM/ref=cm_sw_r_cp_apa_glt_fabc_5WDX48ZT2BW68A4WYMVA?_encoding=UTF8&psc=1M4 12mm Screwshttps://smile.amazon.com/dp/B08HLR3RVR/ref=cm_sw_r_cp_apa_glt_fabc_QBJGVECX5DCE65X2HK6B?psc=1M4 T-Nutshttps://smile.amazon.com/dp/B08145QK3B/ref=cm_sw_r_cp_apa_glt_fabc_WK46E1MM6WM4QHX36P26?_encoding=UTF8&psc=1