M.A.S.K Boulder Hill Gas pump connector

cults3d

These pieces seem to be like gold dust. So I gave it a go at modelling one. The clips are a little fragile, despite making the base of each clip thicker as much as possible. But they do hold the pump in. Probably better than the originals do now, just be careful removing the pump after. Slightly filleted the leading edges of the clips so it goes in but you may need to sand or file slightly to fit as the pumps seem to vary in quality and thickness of the plastic. I personally haven't tested the clicker bit as my replacement is on the on the non-clicky hole. But I followed the measurements of an original.